Installation & User GuideModel: R104-11METROBILITY®FOUR-PORT SWITCHPWR10/100 BASELKATLKATLKATLKAT1234
10 Installation GuideConnect to the NetworkTo connect the R104 to the network, insert the twisted-pair cables intothe appropriate connectors. Be sur
Metrobility 4-port Switch 11User GuideThis section contains information regarding the operating features of theMetrobility R104.LED IndicatorsThe
12 User GuideTechnical SpecificationsNetwork ConnectionsTwisted-Pair InterfaceConnector __________________________________ Shielded RJ-45, 8-pin jac
Metrobility 4-port Switch 13Product Safety, EMC and ComplianceStatementsThis equipment complies with the following requirements:•UL• CSA•CE•CB• FC
14 User GuideWarranty and ServicingTelco Systems’ Product WarrantyTELCO MAKES NO WARRANTIES EXCEPT AS HEREIN SET FORTH: Telcowarrants that the equip
Metrobility 4-port Switch 15Replacement, Repair or Refund Procedure for Hardware: Telco’s sole obligationunder this express warranty shall be, at
5660-000023 D12/06US Headquarters2 Hampshire Street Suite 3AFoxboro MA USA 02035tel: 1.781.551.0300 • fax: 1.781.255.2344www.telco.com
This publication is protected by the copyright laws of the United States and other countries, with all rightsreserved. No part of this publication may
Table of ContentsMetrobility 4-port Switch Installation & User GuideOverview...
4 OverviewOverviewThe Metrobility® R104-11 is a four-port 10/100Mbps TX switch thatprovides a cost-effective solution for situations in which a sim
Metrobility 4- port Switch 5Installation GuideFollow the simple steps outlined in this section to install and start using theR104.NOTE: Electrostatic
6 Installation Guide*DIP switches also can be managed via console commands or with the Metrobility NetBeacon® or WebBeacon™management software. Refe
Metrobility 4- port Switch 7Duplex Switch (FD)Switch FD determines the duplex mode on all ports that have auto-negotiation disabled.• The ports will
8 Installation GuideAN indicates that auto-negotiation is enabled.+ indicates the switch is enabled (OPEN) .— indicates the switch is disabled (CLOS
Metrobility 4- port Switch 9• Insert the card into either slot in the R400 or R1000. In the R5000chassis,any slot excluding slot #17. Make sure the t
Commentaires sur ces manuels